Girl's birthday card pop out- inside

To learn how to make the cover for this card click here. To learn how to make a pop out cake click here.

To decorate this cake you will need:

• Decorative Edged Scissors 
• Zebra Felt
• Black, White, and Pink cardstock
• Hole punch
• X-acto Knife
• Small Paint Brush
• White Paint
• Orange cardstock (I used the paint swatches you can get at the store for free)
• Cutting board
• Double sided tape
• Glue (Elmer's glue would work fine)
• Rubber Cement

Note: Attach all pieces when told to

1. Cut the edges edge of the white cardstock 1 centimeter in on all sides
2. Cut a strip of felt 5 inches long and 1/2 tall for the third tier
3. Cut a strip of pink cardstock 4 inches long and 1/2 in. tall. 
4. Cut a white strip that is 4 inches long and 1/2 in. tall. Trim the edges with decorative edge scissors. Attach this strip to the pink cardstock you cut in step 3.
5. Cut a strip of felt that is 3 inches long and 1/2 in. tall.
6. Use a stencil to draw flowers on pink cardstock or free-style it. Cut them out with an X-Acto knife. Make 3 pink flowers. 
7. Use a hole punch to cut  circles out of white cardstock. These are going to be the centers for your flowers.
8. Draw a simple 5 petaled flower on the zebra felt. Cut it out with your scissors.
9. Attach all of the strips and flowers Using double sided tape. The strips of felt and paper go in the middle or each tier. Two pink flowers go on the 3rd tier, 1 pink flower goes on the top tier. Put the zebra flower on the middle tier.
10. This card could fit up to 16 candles. 
11. Cut pink and black candles out of cardstock. These are 1 1/2 inches tall and 1/2 in. thick.
12. Use a small paint brush to paint white polka dots on the candles.
13. Cut out candle flames from orange cardstock or from a paint swatch.
14. Put a little glue on the top of each candle and attach the candle flames.
15. Put double sided tape on the bottom of the front side of the candle. 
16. Peel off the backing on the double sided tape and attach the candles behind the tier.
17. Before you glue the liner to the card, measure the edges of the cover in 1 centimeter so that the liner looks even.
18. Coat the liner with rubber cement and place onto the card. 
19. If there is any rubber cement seeping out of the edges rub it off with an eraser or your finger.